Header and Extended Piece Installation(KD)

• Put header and extender up as template for anchor installation
• Remove header and extender
• Drill 1/2" quick bolts, or thread rod with epoxy, anchoring system
  (installer preference, not provided by Weizel)
• Cut quick bolts/thread rod flush to block
• * header/extended peice must be installed flush to block work; block
  protruding off flush line must be ground down by installer.

Jamb Installation

• Fit jambs to block(installer may have to adjust length of jamb due to floor tolerances)
• Drill 3/8" quick bolts(not provided by Weizel)
• All quick bolts should be torqued in place
• Then cut flush with frame
• Puddle weld bolts to frame

Weld Header/Extended Piece to wall

• Puddle weld header/extended piece to wall
• Weld top jamb completely to header

Install Trackset

• Install track set level; trackset must sit flush against framework for welding
• Bottom of Trackset Point to be measured as follows:
  • ex: if Clear Opening = 2110
  • set bottom of trackset at 30mm above 2110
  • However, if floor is not level you must set at 2140 (2110 + 30) at highest point off finished floor

Install Rollers to Door Hanger and Hang Door

• Temporarily install track set cover and adjust door to proper height. Installer should ensure that door hanger and cover do not interfer with each other

Install Floor Mounted Guide

• Check distance(with door in closed position) between door and frame lock jamb at top of door
• This distance must be maintained through height of door at lock jamb side.
• Install floor guide as required using 4 - 3/8" quick bolts(not provided by Weizel)

Weld on Receiver Column

• Line up lock bolt in open position with receiver column keeper pocket.
• Receiver column may have to be adjusted off face of frame due to walls out of plum

Install Track Set Cover with screws provided